Chevrolet Equinox manuals

Chevrolet Equinox Service Manual: Wheel Replacement Wheels

Chevrolet Equinox Service Manual / Chassis / Wheels/Tires / Wheel Replacement Wheels

Replace any wheel that is bent, cracked, or badly rusted or corroded. If wheel nutskeep coming loose, the wheel, wheel bolts, and wheel nuts should be replaced. If thewheel leaks air, replace it. Some aluminum wheels can be repaired. See your dealerif any of these conditions exist.

Your dealer will know the kind of wheel that is needed.

Each new wheel should have the same load-carrying capacity, diameter, width, offset,and be mounted the same way as the one it replaces.

Replace wheels, wheel bolts, wheel nuts, or Tire Pressure Monitor System (TPMS) sensorswith new GM original equipment parts.

Warning:Using the wrong replacement wheels, wheel bolts, or wheelnuts can be dangerous. It could affect the braking and handling ofthe vehicle. Tires can lose air, and cause loss of control, causinga crash. Always use the correct wheel, wheel bolts, and wheel nutsfor replacement.

Caution:The wrong wheel can also cause problems with bearing life, brake cooling, speedometeror odometer calibration, headlamp aim, bumper height, vehicle ground clearance, andtire or tire chain clearance to the body and chassis.

Used Replacement Wheels

Warning:Replacing a wheel with a used one is dangerous. How it hasbeen used or how far it has been driven may be unknown. It couldfail suddenly and cause a crash. When replacing wheels, use a newGM original equipment wheel.

Tire Pressure Indicator Sensor Replacement TPMS
Removal ProcedureRaise the vehicle on a suitable support. Refer toLifting and Jacking the Vehicle.Remove the tire/wheel assembly from the vehicle. Refer toTire and Wheel Removal and Installation.Note: ...

Replacement Wheels Description Wheels
Replace the wheel if any of the following conditionsexist:The wheel exhibits excessive runout.The wheel is bent.The wheel is cracked.The wheel is severely rusted.The wheel is severely corroded.Note:Ai ...

Other materials:

Engine Coolant Thermostat Housing Installation Engine Cooling Thermostat
Install a NEW gasket onto the thermostat housing.Install the thermostat housing.Caution:Refer toFastener Caution.Install the thermostat housing bolts. Ensure to install theshort bolts-(1) and the long bolt-(2) in theproper position and tighten to10-Y(89-lb-in). ...

© 2017-2024 Copyright