Chevrolet Equinox Service Manual: Universal Remote System Operation

Chevrolet Equinox Service Manual / Body / Driver Info & Control / Universal Remote System Operation

Using the Universal Remote System

Press and hold the appropriate Universal Remote system button for at least one-halfsecond. The indicator light will come on while the signal is being transmitted.

Erasing Universal Remote System Buttons

Erase all programmed buttons when vehicle ownership is terminated.

To erase:

Press and hold the two outside buttons until the indicator light begins to flash.This should take about 10 seconds.Release both buttons.Reprogramming a Single Universal Remote System Button

To reprogram any of the system buttons:

Press and hold any one of the buttons. Do not release the button.The indicator light will begin to flash after 20 seconds. Without releasing the button,proceed with Step 1 under “Programming the Universal Remote System.”

Engine Oil

To ensure proper engine performance and long life, careful attention must be paidto engine oil. Following these simple, but important steps will help protect yourinvestment:Always use engine oil appro ...

Body Interior

...

Other materials:

Wheel Alignment - Steering Wheel Angle and/or Front Toe Adjustment Wheels
Position and lock the steering wheel with the vehicle with the wheels in the straightforward position.Loosen both inner tie rod jam nuts.Note:The inner tie rod must rotate freely from the boot seal surface. Do not allow theboot to rotate.Loosen the inner tie rod seal to boot surface.Use a wrench on ...