If an I/M System Status indicator did NOT update to YES during theInspection/Maintenance Complete System Set Procedure, review each indicator and reference this table to determine each DTC associatedwith the I/M System Status Indicator. Each DTC listed below has specific conditionsthat must be met for the diagnostic to run. Included within the conditions are additionalDTCs, which if set, may inhibit the DTCs listed below from running. Reviewingand operating the vehicle within the Conditions for Running for each DTC listed belowwill allow the I/M System Status Indicators to transition to YES. | |
Catalyst | DTC P0420 or P0430 |
EGR/CMP | DTC P05CC-P05CF |
EVAP | DTC P0442DTC P0446DTC P0455 |
Fuel System | DTC P219A or P219B |
Oxygen Sensor | DTC P0133, P013A-P013F, P014A, P014B, P0153, P015A-P015D, or P2270-P2273 |
Oxygen Sensor Heater | DTC P0030-P0032, P0036-P0038, P0050-P0054, P0056-P0060, P0135, P0141, P0155, or P0161 |
Camshaft System | DTC P0011, P0014, P0021, or P0024 |
Special Tools (Diagnostic Tools) Engine Control
Knock Sensor Replacement - Bank 2 Engine Control Engine Control Sensors Knock SensorPiston, Connecting Rod, and Bearing Installation (LAF, LAT, LE5, LE9, LEA, or LUK) Engine Block Cylinder Block Piston Assembly
Note:This procedure is not used in Europe.Special ToolsEN-43966 Connecting Rod GuidesEN 45059 Angle MeterEN-47836 Piston Ring CompressorFor equivalent regional tools, refer toSpecial Tools.Install the connecting rod bearings. Use NEW bearings.Install the bearing inserts into the connecting rod and t ...