Warning If temperature change or pain to the skin cannot be felt, the seat heater may cause burns. To reduce the risk of burns, use care when using the seat heater, especially for long periods of time. Do not place anything on the seat that insulates against heat, such as a blanket, cushion, cover, or similar item. This may cause the seat heater to overheat. An overheated seat heater may cause a burn or may damage the seat. |
If available, the buttons are on the climate control panel. To operate, the engine must be running.
Press or to heat the driver or passenger seat cushion and seatback. Indicator lights on the button show the current setting.
Press the button once for the highest setting. With each press of the button, the heated seat will change to the next lower setting, and then to the off setting. The lights indicate three for the highest setting and one for the lowest.
The passenger seat may take longer to heat up.
Press or to ventilate the driver or passenger seat cushion and seatback. Indicator lights on the button show the current setting.
Press the button once for the highest setting. With each press of the button, the ventilated seat will change to the next lower setting, and then to the off setting. The lights indicate three for the highest setting and one for the lowest.
Remote Start Heated and Ventilated Seats
During a remote start, the heated or ventilated seats, if equipped, can be turned on automatically. When it is cold outside, the heated seats turn on, and when it is hot outside the ventilated seats turn on. The heated or ventilated seats are canceled when the ignition is turned on. Press the heated or ventilated seat button to use the heated or ventilated seats after the vehicle is started.
The heated or ventilated seat indicator lights do not turn on during a remote start.
The temperature performance of an unoccupied seat may be reduced.
This is normal.
The remote start heated or ventilated seats may be enabled or disabled in the vehicle personalization menu.
See Remote Vehicle Start and Vehicle Personalization.
Diagnostic Repair Verification
Note:After a repair has been made, some DTCs require the ignition to be turned OFF thenback ON before the scan tool function will clear the DTC.Ignition OFF.Install any components or connectors that have been removed or replaced during diagnosis.Perform any adjustment, programming or setup procedure ...