Warning:Fuel that flows out at high pressure can cause serious injuryto the skin and eyes. ALWAYS depressurize the fuel system beforeremoving components that are under high fuel pressure.
Note:If a scan tool is not available, WAIT at LEAST 2-hours after the engine has been run,before removing the high pressure fuel line.
Disconnect the fuel tank wiring harness to the body wiring harness connector.Start the vehicle and allow the engine to idle until the engine stops. The enginewill stop in approximately 20–30 seconds.Turn the ignition OFF.Using a scan tool, verify that there is little to no fuel pressure, if there stillis fuel pressure repeat step-2.
Transmission Internal Mode Switch Logic Transmission Control Transmission Control Sensors Transmission Range Switch
Automatic Transmission Shift Lock Control Function Check Transmission Control Shift InterlockFront Compartment Side Rail Sectioning
Removal ProcedureWarning:Refer toApproved Equipment for Collision Repair Warning.Warning:Sectioning should be performed only in the recommended areas.Failure to do so may compromise the structural integrity of thevehicle and cause personal injury if the vehicle is in acollision.Disable the SIR syste ...