Chevrolet Equinox Service Manual: Engine Mount Inspection Engine Block Engine Mounts

Chevrolet Equinox Service Manual / Powertrain / Engine / Engine Mount Inspection Engine Block Engine Mounts

Note:Before replacing any engine mount due to suspected fluidloss, verify that the source of the fluid is the engine mount, notthe engine or accessories.

Install the engine support fixture. Refer toEngine Support Fixture.Observe the engine mount while raising the engine. Raisingthe engine removes the weight from the engine mount and createsslight tension on the rubber.Replace the engine mount if the engine mount exhibits any ofthe following conditions:The hard rubber is covered with heat check cracks.The rubber is separated from the metal plate of the enginemount.The rubber is split through the center of the enginemount.The engine mount itself is leaking fluid.For engine mount replacement. Refer toEngine Mount Replacement - Right Side.

Oil Level Indicator and Tube Installation (LAF, LEA, or LUK) Engine Lubrication Oil Level Indicator Tube

Lubricate the oil level indicator tube O-ring.Refer toAdhesives, Fluids, Lubricants, and Sealers.Install the oil level indicator-(2) and the oillevel indicator tube-(1) into the oil pan.Caution:Refer ...

Separating Parts

Note:Disassembly of the piston, press fit design piston pin, andconnecting rod may create scoring or damage to the piston pin andpiston pin bore. If the piston, pin, and connecting rod have beendisass ...

Other materials:

Intake Manifold Disassemble Intake and Forced Induction Intake Manifold
Remove the throttle body bolts-(1).Remove the throttle body-(2).Remove and discard the throttle bodyseal-(3).Loosen the evaporative-(EVAP) solenoidbolt.Remove the EVAP solenoid-(1).Remove the manifold absolute pressure-(MAP) sensorbolt-(1).Remove the MAP sensor-(2).Remove the lower intake manifold b ...