Chevrolet Equinox manuals

Chevrolet Equinox Owners Manual: License Plate Lamp

Lamp Assembly
Lamp Assembly

Bulb Assembly
Bulb Assembly

  1. Bulb Socket
  2.  Bulb
  3.  Lamp Assembly

To replace one of these bulbs:

  1.  Open the liftgate partway. See Liftgate.
  2.  Push the lamp assembly outboard to remove.
  3.  Pull the lamp assembly down to remove it from the liftgate.
  4.  Turn the bulb socket (1) counterclockwise to remove it from the lamp assembly (3).
  5.  Pull the bulb (2) straight out of the bulb socket (1).
  6.  Push the replacement bulb straight into the bulb socket and turn the bulb socket clockwise to install it into the lamp assembly.
  7.  Push the lamp assembly into the liftgate engaging the clip side first.
  8.  Push on the lamp side opposite the clip until the lamp assembly snaps into place.
Taillamps
Driver Side Shown, Passenger Side Similar Sidemarker  Stoplamp/Taillamp/Rear Turn Signal To replace one of these lamps:  Open the liftgate. See Liftgate.  Remove th ...

Replacement Bulbs
Exterior Lamp Bulb Number Base Headlamp HIR2 Sidemarker 194 Stoplamp/Taillamp/ Rear Turn Signal W21WLL License Plate W5WLL ...

Other materials:

Engine Mount Inspection Engine Block Engine Mounts
Note:Before replacing any engine mount due to suspected fluidloss, verify that the source of the fluid is the engine mount, notthe engine or accessories.Install the engine support fixture. Refer toEngine Support Fixture.Observe the engine mount while raising the engine. Raisingthe engine removes the ...

© 2017-2026 Copyright www.cequinox.com