Chevrolet Equinox Service Manual: Heated Seat Control Module Programming and Setup Heated Cooled System
The seat heating control module must be programmed with theproper calibration software. The module stores and utilizes thisinformation however if it is not properly configured with thecorrect calibration software, the seat heating control module willnot control all of the vehicle features properly.
Ensure that the following conditions exist in order toprepare for seat heating control module programming:
The battery is fully charged.The MDI data link connectors are secure.The scan tool is loaded with the most current softwareversion.All disconnected modules and devices are reconnectedsecurely.This entire procedure has been reviewed beforeproceeding.Do not reprogram the seat heating control module unlessdirected by a service procedure or a service bulletin.
Seat Heating Control Module ProgrammingTo program and setup an existing or new replacement seatheating control module, perform the following procedure:
Access the Service Programming System (SPS) and follow theon-screen instructions. Refer toService Programming System (SPS).On the SPS Supported Controllers screen, select HVSMF FrontSeat Heating Control Module - Programming and follow theon-screen instructions.If the HVSMF Front Seat Heating Control Module fails toaccept the program, verify all scan tool and seat heating controlmodule connections are secure.
Note:After programming is completed, perform the following toavoid future misdiagnosis:
Turn the ignition OFF for 10 seconds.Open and close the door.Connect the scan tool to the data link connector.Ignition ON, engine OFF.Clear all DTCs from all modules.
Power Seats System Description and Operation Seats
The driver and passenger 8–way power seat systems each consist of the following components:Seat adjuster switchSeat horizontal motorSeat front vertical motorSeat rear vertical motorSeat recline moto ...
Valve and Seat Grinding Seats
Valve Cleaning ProcedureUse soft bristle wire brush to clean any carbon build-up fromthe valve head. DO NOT use a wire brush on any part of the valvestem. The valve stem is chrome plated to provide en ...
Other materials:
Sunroof Description and Operation (Tilt and Slide System) Moonroof/Sunroof
The tilt/slide sunroof consists of a moving glass panel and a manual sunshade. Inthe tilt/slide sunroof system the rear of the glass tilts up for venting and slidesbetween the head liner and roof panel as it slides open. The glass is controlled byan integrated motor/controller. The sunshade has a me ...
