Chevrolet Equinox Owners Manual: Radio Signals for Some Gate Operators
For questions or programming help call 01-800-466-0811 or see www.homelink.com.
Some gate operators require transmitter signals to time out or quit after several seconds of transmission. This may not be long enough for the Universal Remote system to pick up the signal during programming.
If the programming did not work, replace Step 2 under "Programming the Universal Remote System" with the following: Press and hold the Universal Remote system button while pressing and releasing the hand-held transmitter button every two seconds until the signal has been successfully accepted by the Universal Remote system. The Universal Remote system indicator light will flash slowly at first and then rapidly. Proceed with Step 3 under "Programming the Universal Remote System" to complete.
Programming the Universal
Remote System
For questions or help programming
the Universal Remote system, call
01-800-466-0811 or see
www.homelink.com.
Programming involves
time-sensitive actions, and may time
out causing the procedure ...
Universal Remote System
Operation
Using the Universal Remote
System
Press and hold the appropriate
Universal Remote system button for
at least one-half second. The
indicator light will come on while the
signal is being transmitt ...
Other materials:
Test Probe Caution
Caution:Do not insert test equipment probes (DMM etc.) into any connector or fuse block terminal.The diameter of the test probes will deform most terminals. A deformed terminal willcause a poor connection, which will result in a system failure. Always use the J-35616-FGM Approved Terminal Release To ...
