Chevrolet Equinox manuals

Chevrolet Equinox Owners Manual: Programming the Universal Remote System

For questions or help programming the Universal Remote system, call 01-800-466-0811 or see www.homelink.com.

Programming involves time-sensitive actions, and may time out causing the procedure to be repeated.

To program up to three devices:

  1.  Hold the end of the hand-held transmitter about 3 to 8 cm (1 to 3 in) away from the Universal Remote system buttons with the indicator light in view. The hand-held transmitter was supplied by the manufacturer of the garage door opener receiver.
  2.  At the same time, press and hold both the hand-held transmitter button and one of the three Universal Remote system buttons to be used to operate the garage door. Do not release either button until the indicator light changes from a slow to a rapid flash. Then release both buttons.

    Some garage door openers may require substitution of Step 2 with the procedure under "Radio Signals for Some Gate Operators" later in this section.

  3.  Press and hold the newly programmed Universal Remote system button for five seconds while watching the indicator light and garage door activation.

Learn or Smart Button
Learn or Smart Button

  1. After completing Steps 1-3, locate the Learn or Smart button inside garage on the garage door opener receiver.

    The name and color of the button may vary by manufacturer.

  2.  Press and release the Learn or Smart button. Step 6 must be completed within 30 seconds of pressing this button.
  3.  Inside the vehicle, press and hold the newly programmed Universal Remote system button for two seconds and then release it. If the garage door does not move or the lamp on the garage door opener receiver does not flash, press and hold the same button a second time for two seconds, then release it.

    Again, if the door does not move or the garage door lamp does not flash, press and hold the same button a third time for two seconds, then release it.

The Universal Remote system should now activate the garage door.

Repeat the process for programming the two remaining buttons.

Universal Remote System Programming
If equipped, these buttons are in the overhead console. This system can replace up to three remote control transmitters used to activate devices such as garage door openers, security system ...

Radio Signals for Some Gate Operators
For questions or programming help call 01-800-466-0811 or see www.homelink.com. Some gate operators require transmitter signals to time out or quit after several seconds of transmission. This ...

Other materials:

Control Valve Upper Body Assembly - Lower Body Spacer Plate Side Automatic Transmission Unit
Control Valve Upper Body Assembly– Lower Body Spacer Plate Side(2)Line(3)Decrease(5)TCC Release(6)TCC Apply(7)Cooler Feed(10)Compensator Feed(11)Actuator Feed Limit(14)PCS R1/456 Clutch(19)R1/456 Clutch Feed(20)R1/456 Feedback(21)R1 Supply(22)R1(23)PCS 35 Reverse Clutch(24)Reverse(25)35 Reverse Cl ...

© 2017-2024 Copyright www.cequinox.com