Chevrolet Equinox Owners Manual: Radio Signals for Canada and Some Gate Operators
For questions or programming help call 1-800-355-3515 or see www.homelink.com.
Canadian radio-frequency laws and some U.S. gate operators require transmitter signals to time out or quit after several seconds of transmission. This may not be long enough for the Universal Remote system to pick up the signal during programming.
If the programming did not work, replace Step 2 under "Programming the Universal Remote System" with the following: Press and hold the Universal Remote system button while pressing and releasing the hand-held transmitter button every two seconds until the signal has been successfully accepted by the Universal Remote system. The Universal Remote system indicator light will flash slowly at first and then rapidly. Proceed with Step 3 under "Programming the Universal Remote System" to complete.
Programming the Universal
Remote System
For questions or help programming
the Universal Remote system, call
1-800-355-3515 or see
www.homelink.com.
Programming involves
time-sensitive actions, and may time
out causing the procedure ...
Universal Remote System Programming
If equipped, these buttons are in the
overhead console.
This system can replace up to three
remote control transmitters used to
activate devices such as garage
door openers, security system ...
Other materials:
Cylinder Head Installation (LAF, LEA, or LUK) Engine Block Cylinder Head
Special ToolsEN 45059Angle MeterFor equivalent regional tools, refer toSpecial ToolsNote:Do not use any sealing material.Install the cylinder head gasket to the block.Install the cylinder head. Ensure the number1-cylinder is at top dead center-(TDC). Thekey on the crankshaft should be on top in the ...
