Chevrolet Equinox Service Manual: Memory Seat Control Module Programming and Setup Seating Position
The seat memory control module must be programmed with theproper calibration software. The module stores and utilizes thisinformation however if it is not properly configured with thecorrect calibration software, the seat memory control module willnot control all of the vehicle features properly.
Ensure that the following conditions exist in order toprepare for seat memory control module programming:
The battery is fully charged.The MDI data link connectors are secure.The scan tool is loaded with the most current softwareversion.All disconnected modules and devices are reconnectedsecurely.This entire procedure has been reviewed beforeproceeding.Do not reprogram the seat memory control module unlessdirected by a service procedure or a service bulletin.
Seat Memory Control Module ProgrammingTo program and setup an existing or new replacement seatmemory control module, perform the following procedure:
With a scan tool, access the Service Programming System (SPS)and follow the on-screen instructions. Refer toService Programming System (SPS).On the SPS Supported Controllers screen, select MSM MemorySeat Control Module - Programming and follow theon-screen instructions.If the MSM Memory Seat Module fails to accept the program,verify all scan tool and seat memory control module connections aresecure.
Note:After programming is completed, perform the following toavoid future misdiagnosis:
Turn the ignition OFF for 10 seconds.Open and close the door.Connect the scan tool to the data link connector.Ignition ON, engine OFF.With a scan tool, clear all DTC’s from allmodules.
Vehicle Personalization
Use the audio system controls to access the personalization menus for customizingvehicle features.The following are all possible personalization features. Depending on the vehicle,some may not be avai ...
Other materials:
Secondary Air Injection Check Valve Pipe Replacement Engine Control
Secondary Air Injection Check Valve Pipe ReplacementCalloutComponent NamePreliminary ProcedureRemove the intake manifold cover. Refer toIntake Manifold Cover Replacement.1Secondary Air Injection Check Valve Pipe FastenerCaution:Refer toFastener Caution.Tighten 10-Y(89-lb-in).2Secondary Air Injection ...
