Chevrolet Equinox manuals

Chevrolet Equinox Service Manual: Inflatable Restraint Sensing and Diagnostic Module Programming and Setup

Chevrolet Equinox Service Manual / Body / Restraints / Inflatable Restraint Sensing and Diagnostic Module Programming and Setup

The inflatable restraint sensing and diagnostic module (SDM)must be programmed with the proper calibration software. The modulestores and utilizes this information however if it is not properlyconfigured with the correct calibration software, the SDM will notcontrol all of the vehicle features properly.

Ensure that the following conditions exist in order toprepare for SDM programming:

The battery is fully charged.The MDI data link connectors are secure.The scan tool is loaded with the most current softwareversion.All disconnected modules and devices are reconnectedsecurely.This entire procedure has been reviewed beforeproceeding.

Do not reprogram the SDM unless directed by a serviceprocedure or a service bulletin.

Note:

The air bag indicator light may remain ON after the bodycontrol module (BCM), or SDM is replaced, and during theprogramming procedure for the BCM until after the procedure iscompleted. When installing a new SDM, there may be several DTCs setprior to programming. Once programmed, these DTCs should be inhistory and can be cleared.Failure to complete the following Setup procedure may causeDTC B1001 to be set in the SDM.

The following service procedures require either a programmingor a setup event performed for a complete repair:

Sensing and Diagnostic Module Replacement and/orProgramming

If the inflatable restraint sensing and diagnostic moduleneeds to be replaced and/or reprogrammed, the following proceduresmust be performed:

Access SPS. Refer toService Programming System (SPS).Perform the SPS function Inflatable Restraint Sensing andDiagnostic Module Programming and follow the on-screeninstructions.Perform the SPS function Inflatable Restraint Sensing andDiagnostic Module Setup and follow the on-screeninstructions.Clear DTCs after completing the programming procedure.

If the control module fails to program, proceed asfollows:

Ensure the DLC and Accessory Power Module connections aregood.Inspect the Techline equipment for the latest softwareversion.Attempt to program the SDM. If the SDM still cannot beprogrammed properly, replace the SDM.
#99-09-40-005G: Seat Belt Extender Availability - (Aug 15, 2013) Primary Seat Belts
Subject:Seat Belt Extender AvailabilityModels: 2014 and Prior GM Cars and Trucks  This bulletin has been revised to add the 2012-2014 model years. Please discard CorporateBulletin Number 99-09-40-0 ...

SIR Identification Views Secondary
The SIR Identification Views shown below illustrate theapproximate location of all SIR components available for thevehicle. This will assist in determining the appropriate SIRDisabling and Enabling fo ...

Other materials:

Fuel Pressure Sensor Replacement Engine Control Engine Control Sensors
Removal ProcedureRelieve the fuel system pressure. Refer toFuel Pressure Relief.Raise and suitably support the vehicle. Refer toLifting and Jacking the Vehicle.Disconnect the body wiring harness electricalconnector-(1) from the fuel pressuresensor-(2).Wrap a shop towel around the fuel pressure senso ...

© 2017-2024 Copyright www.cequinox.com