Chevrolet Equinox Owners Manual: Washer Fluid

Chevrolet Equinox Owners Manual / Vehicle Care / Vehicle Checks / Washer Fluid

What to Use

When windshield washer fluid is needed, be sure to read the manufacturer's instructions before use. If operating the vehicle in an area where the temperature may fall below freezing, use a fluid that has sufficient protection against freezing.

Adding Washer Fluid

Adding Washer Fluid

Open the cap with the washer symbol on it. Add washer fluid until the tank is full. See Engine Compartment Overview for reservoir location.

Caution

Do not use washer fluid that contains any type of water repellent coating. This can cause the wiper blades to chatter or skip.
Do not use engine coolant (antifreeze) in the windshield washer. It can damage the windshield washer system and paint.
Do not mix water with ready-to-use washer fluid.
Water can cause the solution to freeze and damage the washer fluid tank and other parts of the washer system.
When using concentrated washer fluid, follow the manufacturer instructions for adding water.
Fill the washer fluid tank only three-quarters full when it is very cold. This allows for fluid expansion if freezing occurs, which could damage the tank if it is completely full.

Engine Overheating

The vehicle has an engine coolant temperature gauge on the instrument cluster and overheat messages in the Driver Information Center (DIC) to warn of engine overheating. See Engine Coolant Tempe ...

Brakes

Disc brake pads have built-in wear indicators that make a high-pitched warning sound when the brake pads are worn and new pads are needed. The sound can come and go or can be heard all the time ...

Other materials:

Piston, Connecting Rod, and Bearing Installation (LAF, LAT, LE5, LE9, LEA, or LUK) Engine Block Cylinder Block Piston Assembly
Note:This procedure is not used in Europe.Special ToolsEN-43966 Connecting Rod GuidesEN 45059 Angle MeterEN-47836 Piston Ring CompressorFor equivalent regional tools, refer toSpecial Tools.Install the connecting rod bearings. Use NEW bearings.Install the bearing inserts into the connecting rod and t ...