1 | Lock Pin Warning:Lock pin must be secured into the bench fixture to hold thetransmission and prevent bodily injury. Note:Ensure the DT 3289-20 holding fixture is mounted to a bench that is properly supported and will support the weight of thetransmission assembly without tipping. DT-39890 holding fixture adapter adapter and an engine stand can be used as an alternative method for supporting thetransmissionassembly during repairs. Special ToolsDT 3289-20 Holding FixtureDT-39890 Transmission Holding Fixture AdapterFor equivalent regional tools, refer toSpecial Tools. |
2 | DT 21366 Converter Holding Strap For equivalent regional tools, refer toSpecial Tools. |
3 | Dust Cover Bolts-M10-x-25, model dependent (Qty:-2) |
4 | Dust Cover Push Pin, model dependent |
5 | Dust Cover, model dependent |
6 | Torque Converter Assembly Caution:Only install the lift assist handles until it stops. Do nottighten. Over tightening the lift assist handles can cause damageto the torque converter. Note:Failure to raise the torque converter straight up could damage the torque converterclutch lip seal inside the torque converter clutch assembly. Special Tools DT 46409 Torque Converter Lifting Handles For equivalent regional tools, refer toSpecial Tools. |
Doing Your Own Service Work
Warning:It can be dangerous to work on your vehicle if you do not have the proper knowledge,service manual, tools, or parts. Always follow owner manual procedures and consultthe service manual for your vehicle before doing any service work.If doing some of your own service work, use the proper servi ...