1 | Torque Converter Assembly Caution:Lower the torque converter straight down. Failure to lowerthe torque converter straight down could damage the torqueconverter clutch lip seal inside the torque converter clutchassembly. Special Tools DT 46409Torque Converter Lifting Handles For equivalent regional tools, refer toSpecial Tools. |
2 | DT 21366Converter Holding Strap Warning:The torque converter must be held to the torque converterhousing by a retaining device such as shipping brackets. Withoutthe retaining device, the torque converter may slide forward,disengaging the oil pump, or may fall completely out of thetransmission causing personal injury and/or property damage. |
3 | Dust Cover-–-ModelDependant |
4 | Dust Cover Push Pin-–-ModelDependant (Qty: 2) |
5 | Dust Cover Bolt-–-ModelDependant Caution:Refer toFastener Caution. Tighten75-Y(37-lb-ft) |
Cylinder Head Installation (LAF, LEA, or LUK) Engine Block Cylinder Head
Special ToolsEN 45059Angle MeterFor equivalent regional tools, refer toSpecial ToolsNote:Do not use any sealing material.Install the cylinder head gasket to the block.Install the cylinder head. Ensure the number1-cylinder is at top dead center-(TDC). Thekey on the crankshaft should be on top in the ...