Chevrolet Equinox Service Manual: Steering Angle Sensor Centering Sensors Steering Angle Sensor

Chevrolet Equinox Service Manual / Chassis / Brake Control and Vehicle Dynamics / Steering Angle Sensor Centering Sensors Steering Angle Sensor

The steering angle sensor does not require centering often. Centering of the steeringangle sensor might be required after certain service procedures are performed. Someof these procedures are as follows:

Wheel alignmentSteering gear replacementSteering column replacementSteering angle sensor replacementCollision or other physical damageElectronic brake control module-(EBCM) replacement

The steering angle sensor centering procedure can be completed with a scan tool usingthe following steps:

Using the steering wheel, align the front wheels in the center forward position.Apply the parking brake, or set the transmission in the P-position.Install the scan tool to the data link connector.Ignition ON, engine OFFSelect Steering Wheel Angle Sensor Reset in the Steering Wheel Angle Sensor ModuleConfiguration/Reset Functions list.Follow the scan tool directions to complete the Reset procedure.Select Steering Wheel Angle Sensor Learn in the Steering Wheel Angle Sensor ModuleConfiguration/Reset Functions list.Follow the scan tool directions to complete the Learn procedure.Select Steering Wheel Angle Sensor Learn in the Electronic Brake Control Module Configuration/ResetFunctions list.Follow the scan tool directions to complete the Learn procedure.Clear any DTCs that may be set.

Brake Pressure Modulator Valve Pressure Sensor Calibration Dynamics Control ABS Control

The brake pressure sensor does not require calibration often.Calibration of the brake pressure sensor might be required aftercertain service procedures are performed. Some of these proceduresare as fo ...

Vehicle Yaw Sensor Learn Dynamics Control ABS Control

The yaw sensor does not require calibration often.Calibration of the yaw rate sensor might be required after certainservice procedures are performed. Some of these procedures are asfollows:Electronic ...

Other materials:

Checking and Adding Power Steering Fluid Hydraulic Steering
Run the engine until the power steering fluid reaches about80°C (170°F).Turn the engine OFF.If the power steering fluid reservoir is covered by a shieldor a cover, remove the shield or the cover, as applicable.Clean the power steering fluid reservoir and the reservoircap.Remove the reservoir cap.N ...