Chevrolet Equinox Service Manual: Reset Transmission Adapts Automatic Transmission Unit
The Reset Transmission Adapts is a procedure for automatictransmissions in which the shift pressure learn values of eachindividual clutch is reset to zero or a base calibrated value, inthe transmission control module-(TCM).
Once the transmission adapts are set to zero or a calibratedvalue, the vehicle is then road test under various drive cycleevents for the TCM to relearn shift pressure values for the bestpossible shift feel in all gear ranges.
The Reset Transmission Adapts procedure must be performedwhen one of the following repairs have been made to thetransmission. Failure to perform the procedure after one of thefollowing repairs may result in poor transmission performance, DTCsbeing set, or customer dissatisfaction.
Transmission internal service, repair or overhaulValve body repair or replacementControl solenoid valve assembly replacementAny service/repair in response to a shift qualityconcernInstall any components or connectors that have been removedor replaced during diagnosis.Perform any adjustments, programming or setup procedures thatare required when a component or module is removed orreplaced.Clear the DTCs.Ignition OFF, all vehicle systems OFF, this may take up to2-minutes.Note:Do not cycle or turn the ignition switch OFF until directedto do so below.
Ignition ON, engine running, with a scan tool ResetTransmission Adapts.Perform theRoad Test.Ignition OFF for 2-minutes.
New Product Information Automatic Transmission Unit
The purpose of New Product Information is to document, important product changes whichoccur either model year-to-model year or interim model year.Changes may include one or more of the following items ...
Definitions and Abbreviations Automatic Transmission Unit
Throttle PositionsEngine BrakingA condition where the engine is used to slow the vehicle bymanually downshifting during a zero throttle coastdown.Full Throttle DownshiftA quick apply of the accelerato ...
Other materials:
Front Side Door Lock Cylinder Coding Locks Mechanical Locks
The door lock cylinder uses 6 of the 8-cutpositions, 3 through 8. The tumbler positions are staggered fromside to side, 3 on one side and 3 on the other, are notself-retaining, and are not snap in.Note:All lock cylinders for side milled keys have right and lefttumblers. The location of the tooth of ...
