Removal Procedure
Remove the rear seat. Refer toRear Seat Removal and Installation.Remove the fastener from the rear seat back latch and pullthe latch out from the seat back assembly.
Detach the latch cable from the latch.
If you are going to replace the cable, disconnect the latchcable at the seat recliner mechanism.
Open the J-strip at the bottom of the seat cover.
Attach a mechanics wire to the cable to guide it through theseat back.Pull the cable out from the seat back assembly.Installation Procedure
Attach a mechanics wire to the new cable to guide it throughthe seat back.If you are replacing the cable, route the cable through therear seat back.
Connect the latch cable to the recliner mechanism.
Connect the J-strip at the bottom of the seat cover.Connect the latch cable to the latch assembly.
Caution:Refer toFastener Caution.
Install the latch to the seat back with a fastener andtighten to2.5-Y(22-lb-in).Install the rear seat. Refer toRear Seat Removal and Installation.Oil Pump Disassemble Engine Lubrication Oil Pump
Remove the pressure relief plug-(1),spring-(2), and plunger-(3).Remove the oil pump gerotor cover-(1) andbolts.Clean all of the parts in cleaning solvent. Remove varnish,sludge and dirt.Inspect the oil pump-(2, 3) for wear and scoring.Ensure that all components are within specifications. Refer toEng ...