Loosen the upper control arm-to-frame fastener enough toallow movement.
Note:The frame of the vehicle is slotted, turning the cam nut willmove the camber in to the designated location.
Rotate the upper control arm-to-frame fastener in thedirection necessary to the correct the camber measurement.Snug the upper control arm-to-frame fastener, do not tightenat this time.Reinspect the rear camber specifications and adjust asnecessary.Caution:Refer toFastener Caution.
Hold the nut and tighten the upper control arm-to-frame boltto164-Y(121-lb-ft).Repeat the procedure for the other rear wheel.Balance Shaft Removal Engine Block Cylinder Block Balance Shaft
Note:This procedure is not used in Europe.Special Tools EN-43650 Balancer Shaft Bearing Remover and InstallerFor equivalent regional tools, refer toSpecial Tools.Remove the balance shaft bearing carrier bolts.Note:It is possible to install the intake side balance shaft into the exhaust side andvice ...