For questions or programming help call 1-800-355-3515 or see www.homelink.com.
Canadian radio-frequency laws and some U.S. gate operators require transmitter signals to time out or quit after several seconds of transmission. This may not be long enough for the Universal Remote system to pick up the signal during programming.
If the programming did not work, replace Step 2 under "Programming the Universal Remote System" with the following: Press and hold the Universal Remote system button while pressing and releasing the hand-held transmitter button every two seconds until the signal has been successfully accepted by the Universal Remote system. The Universal Remote system indicator light will flash slowly at first and then rapidly. Proceed with Step 3 under "Programming the Universal Remote System" to complete.
Programming the Universal
Remote System
Universal Remote System ProgrammingEngine Front Cover Assemble Engine Block Cylinder Block Cyl Block Front Cover
Special ToolsEN 29184Oil Seal InstallerEN 46103Camshaft Actuator Valve Seal InstallerFor equivalent regional tools, refer toSpecial Tools.Important:Do not lubricate the crankshaft front oil seal or crankshaftbalancer sealing surfaces. The crankshaft balancer is installedinto a dry seal.Install the N ...