Chevrolet Equinox Service Manual: Manual Shift Detent Lever with Shaft Position Switch Assembly and Park Pawl Actuator Installation Automatic Transmission Unit
1 | Park Pawl Actuator Guide |
2 | Park Pawl Actuator Guide Pin |
3 | Park Pawl |
4 | Park Pawl Shaft |
5 | Park Pawl Spring |
6 | Park Pawl Actuator Bracket |
7 | Park Pawl Actuator Bracket Bolt-M6-x-25 (Qty: 2) Caution:Refer toFastener Caution. Tighten12-Y (106-lb-in). |
8 | Park Pawl Actuator Assembly Note:Install the park pawl actuator assembly onto the detent lever assembly. |
9 | Manual Shaft Detent (w/Shift Position Switch) Lever Assembly Note: Rotate the assembly clockwise so the actuator rod will fit through the case opening.Lubricate shaft with ATF to prevent damage to the manual shift shaft seal. |
10 | Manual Shift Shaft Pin Caution:Use J-41229 to install the manual shaft pin at thecorrect height in order to properly secure the manual shaft. If youinstall the pin too deep, the case bore may crack. ProcedureUse a NEW pin to ensure proper engagement to the case.Inspect pin installed height is within 6.5–7.5-mm (0.25–0.30-in).Special Tools DT 41229 Manual Shaft Pin Installer For equivalent regional tools, refer toSpecial Tools. |
Low and Reverse Clutch Plate Removal Automatic Transmission Unit Automatic Clutches
Low and Reverse Clutch Plate RemovalCalloutComponent Name1Low and Reverse Clutch Cushion (Waved) Spring2Low and Reverse Clutch Apply Plate3Low and Reverse Clutch (w/Friction Material) Plate Assembly(Q ...
Manual Shift Detent Lever with Shaft Position Switch Assembly and Park Pawl Actuator Removal Automatic Transmission Unit
Manual Shift Detent Lever with Shaft Position Switch Assembly and Park Pawl ActuatorRemovalCalloutComponent Name1Park Pawl Actuator Bracket Bolt-M6-x-25 (Qty: 2)2Park Pawl Actuator Bracket3Park Pawl S ...
Other materials:
Front Differential Carrier Bearing Replacement Automatic Transmission Unit
Table 1: RemovalTable 2: InstallationRemovalRemovalCalloutComponent Name1Front Differential Carrier Bearing AssemblySpecial ToolsDT-41816 Three Legged PullerDT 41816-2 Step PlateFor equivalent regional tools, refer toSpecial Tools.2Inner RaceNote:Ensure all 3 legs of the puller make contact with the ...
