Chevrolet Equinox manuals

Chevrolet Equinox Owners Manual: If a Tire Goes Flat

It is unusual for a tire to blow out while driving, especially if the tires are maintained properly. See Tires. If air goes out of a tire, it is much more likely to leak out slowly.

But if there is ever a blowout, here are a few tips about what to expect and what to do: If a front tire fails, the flat tire creates a drag that pulls the vehicle toward that side. Take your foot off the accelerator pedal and grip the steering wheel firmly. Steer to maintain lane position, and then gently brake to a stop, well off the road, if possible.

A rear blowout, particularly on a curve, acts much like a skid and may require the same correction as used in a skid. Stop pressing the accelerator pedal and steer to straighten the vehicle. It may be very bumpy and noisy. Gently brake to a stop, well off the road, if possible.

Warning Driving on a flat tire will cause permanent damage to the tire.

Re-inflating a tire after it has been driven on while severely underinflated or flat may cause a blowout and a serious crash.

Never attempt to re-inflate a tire that has been driven on while severely underinflated or flat.

Have your dealer or an authorized tire service center repair or replace the flat tire as soon as possible.

 

Warning Lifting a vehicle and getting under it to do maintenance or repairs is dangerous without the appropriate safety equipment and training. If a jack is provided with the vehicle, it is designed only for changing a flat tire. If it is used for anything else, you or others could be badly injured or killed if the vehicle slips off the jack. If a jack is provided with the vehicle, only use it for changing a flat tire.

If a tire goes flat, avoid further tire and wheel damage by driving slowly to a level place, well off the road, if possible. Turn on the hazard warning flashers. See Hazard Warning Flashers.

Warning Changing a tire can be dangerous. The vehicle can slip off the jack and roll over or fall causing injury or death. Find a level place to change the tire. To help prevent the vehicle from moving:
  1.  Set the parking brake firmly.
  2. Put an automatic transmission in P (Park) or a manual transmission in 1 (First) or R (Reverse).
  3.  Turn off the engine and do not restart while the vehicle is raised.
  4.  Do not allow passengers to remain in the vehicle.
  5.  Place wheel blocks, if equipped, on both sides of the tire at the opposite corner of the tire being changed.

This vehicle may come with a jack and spare tire or a tire sealant and compressor kit. To use the jacking equipment to change a spare tire safely, follow the instructions below.

Then see Tire Changing. To use the tire sealant and compressor kit, see Tire Sealant and Compressor Kit.

When the vehicle has a flat tire (2), use the following example as a guide to assist you in the placement of wheel blocks (1), if equipped.

If a Tire Goes Flat

  1. Wheel Block (If Equipped)
  2.  Flat Tire

The following information explains how to repair or change a tire.

Tire Chains
Warning Do not use tire chains. There is not enough clearance. Tire chains used on a vehicle without the proper amount of clearance can cause damage to the brakes, suspension, ...

Tire Sealant and Compressor Kit
Warning Idling a vehicle in an enclosed area with poor ventilation is dangerous. Engine exhaust may enter the vehicle. Engine exhaust contains carbon monoxide (CO) which canno ...

Other materials:

#PIT5236: Diagnostic Tip: OnStar Module Does Not Support All B101D Symptom Codes - (Oct 3, 2013)
Subject:Diagnostic Tip: OnStar Module Does Not Support All B101D Symptom CodesModels: 2011 - 2014 All GM Passenger Car and Light Duty Trucks with RPO UE1(Except 2011-2013 Chevrolet Corvette, 2011-2012 Chevrolet Colorado, 2011-2012 GMCCanyon)The following diagnosis might be helpful if the vehicle ex ...

© 2017-2024 Copyright www.cequinox.com