Chevrolet Equinox Owners Manual: Headlamps
Driver Side Shown, Passenger Side Similar
- Headlamp
To replace one of the headlamp bulbs:
- Open the hood. See Hood.
- For the driver side bulb,
remove the battery cover.
Remove the windshield washer bottle filler neck by firmly pulling it straight up and out of the bottle.
For the passenger side, remove the air cleaner cover.
- Remove the cover from the back of the headlamp assembly by turning it counterclockwise.
- Disconnect the electrical connector.
- Remove the bulb from the lamp assembly by turning counterclockwise.
- Install a new bulb in the lamp assembly.
- Connect the electrical connector.
- Replace the cover from the back of the headlamp assembly by turning it clockwise.
- For the driver side, reinstall the
battery cover. Reinstall the
windshield washer bottle filler
neck by firmly pushing it
straight into the bottle. Make
sure that the filler neck clip
engages into the bracket on
the upper tie-bar.
For the passenger side, reinstall the air cleaner cover.
Halogen Bulbs
Warning
Halogen bulbs have pressurized
gas inside and can burst if you
drop or scratch the bulb. You or
others could be injured. Be sure
to read and follow the instructions
on ...
Taillamps
Driver Side Shown, Passenger Side Similar
Sidemarker
Stoplamp/Taillamp/Rear
Turn Signal
To replace one of these lamps:
Open the liftgate. See Liftgate.
Remove th ...
Other materials:
Propeller Shaft Description and Operation Driveshafts Propeller Shaft Assembly
The propeller shaft assembly is a 2-piece design.The front shaft consists of a plunging A-type constantvelocity joint at the front and a universal joint and yoke at therear.The rear shaft consists of a center bearing and a centeryoke, which are pressed onto the rear half of the propshaft andretained ...
© 2017-2024 Copyright www.cequinox.com
