Chevrolet Equinox Service Manual: Fuel Pressure Relief Engine Control

Chevrolet Equinox Service Manual / Powertrain / Internal Combustion Powertrain Control / Fuel Pressure Relief Engine Control

Warning:Fuel that flows out at high pressure can cause serious injuryto the skin and eyes. ALWAYS depressurize the fuel system beforeremoving components that are under high fuel pressure.

Note:If a scan tool is not available, WAIT at LEAST 2-hours after the engine has been run,before removing the high pressure fuel line.

Disconnect the fuel tank wiring harness to the body wiring harness connector.Start the vehicle and allow the engine to idle until the engine stops. The enginewill stop in approximately 20–30 seconds.Turn the ignition OFF.Using a scan tool, verify that there is little to no fuel pressure, if there stillis fuel pressure repeat step-2.

Transmission Internal Mode Switch Logic Transmission Control Transmission Control Sensors Transmission Range Switch

Transmission Internal Mode Switch LogicGear Selector PositionSignal ASignal BSignal CSignal PParkLOWHIHILOWPark/ReverseLOWLOWHILOWReverseLOWLOWHIHIReverse/NeutralHILOWHIHINeutralHILOWHILOWNeutral/Driv ...

Automatic Transmission Shift Lock Control Function Check Transmission Control Shift Interlock

Warning:When you are doing this inspection, the vehicle could movesuddenly. If the vehicle moves, you or others could beinjured.Before starting this check, be sure there is enough room around the vehi ...

Other materials:

Piston and Connecting Rod Assemble Engine Block Cylinder Block Piston Assembly
Special ToolsEN-46121 Connecting Rod Guide Pin SetEN-46745 Piston Pin Clip Remover/InstallerFor equivalent regional tools, refer toSpecial ToolsPiston and Piston Pin Installation ProcedureNote:The piston is directional and must be installed in the engine block in the properdirection. The dot on the ...