Preliminary Procedure Remove the transmission. Refer toTransmission Replacement. Special Tools EN-43653Engine Flywheel Holding Tool. For equivalent regional tools, refer toSpecial Tools. | |
1 | Engine Flywheel Fastener (Qty:-6) Caution:Refer toFastener Caution. Note:Discard old bolts and use NEW bolts duringinstallation. Tighten53-Y(39-lb-ft)Tighten the bolt an additional 25-degrees. |
2 | Engine Flywheel Spacer |
3 | Engine Flywheel Plate Procedure Inspect the engine flywheel for the following: Stress cracks around the engine flywheel .Cracks at welded areas that retain the ring gear onto theengine flywheel.Damaged or missing ring gear teeth.Do not attempt to repair the welded areas that retain thering gear to the engine flywheel. |
Balance Shaft Cleaning and Inspection Engine Block Cylinder Block Balance Shaft
Clean the balance shafts-(1) in solvent.Inspect the bearing surfaces on the balance shafts forscoring or unusual wear.Note:Do not remove the balance shaft drive sprockets.Inspect the balance shaft drive sprockets for wear, damage,or missing teeth.Measure the rear bearing journals on the balance shaf ...