Warning:In order to prevent accidental deployment and the risk ofpersonal injury, do not dispose of an undeployed inflatablerestraint seat belt pretensioner as normal shop waste. Undeployedseat belt pretensioners contain substances that could cause severeillness or personal injury if their sealed containers are damagedduring disposal. Use the following deployment procedures to safelydispose of an undeployed seat belt pretensioner. Failure to observethe following disposal methods may be a violation of federal,state, or local laws. Warning:Refer toSIR Warning. Warning:Refer toSIR Inflator Module Handling and Storage Warning. Preliminary ProceduresMove the front seat to a full forward and full up position.Disable the SIR. Refer toSIR Disabling and Enabling.Remove the upper and lower center pillar trim panel. Refer toCenter Pillar Upper Trim Panel ReplacementandCenter Pillar Lower Trim Panel Replacement. | |
1 | Front Seat Belt Tensioner Fastener Caution:Refer toFastener Caution. Tighten7.5-Y (66-lb-in) |
2 | Driver or Passenger Seat Shoulder Belt Guide Fastener Tighten45-Y (33-lb-ft) |
3 | Driver or Passenger Seat Shoulder Belt Retractor Fastener Tighten45-Y (33-lb-ft) |
4 | Driver or Passenger Seat Belt Push On Retainer Procedure Use a flat-bladed tool to remove locking pin in retainer. |
5 | Driver or Passenger Seat Retractor Side Belt Assembly ProcedureDisconnect the electrical connector.Refer toPretensioner Handling and Scrapping. |
Wheel Alignment and Tire
Balance
The tires and wheels were aligned
and balanced at the factory to
provide the longest tire life and best
overall performance. Adjustments to
wheel alignment and tire balancing
are not necessary on a regular
basis. Consider an alignment check
if there is unusual tire wear or the
vehicle is sig ...