Special Tools
BO-51098 Flip Key Blade Fixture
For equivalent region tools, refer toSpecial Tools.
Caution:Failure to properly support the Remote Keyless Entry (RKE) transmitter assembly whilereplacing the key blade may cause internal damage to the transmitter assembly.
Insert the RKE transmitter in the fixture as shown.Note:It may be necessary to dress the pin drift on a grinder to maintain the diameter inorder to drive the pin through the housing.
Using the BO-51098 fixture, drive the retention pin from the transmitter assembly as shown.Remove the key blade from the transmitter assembly.Install the coded blank into the transmitter assembly, insure the indentation on thekey blade faces the retention pin.
Note:Use caution not to damage the surface, chrome plating, in the following steps.
Using needle nose pliers, insert the pin half way into the transmitter assembly.Using the BO-51098 fixture, drive the roll pin flush to the surface.
General Information
Your vehicle is an important
investment. This section describes
the required maintenance for the
vehicle. Follow this schedule to help
protect against major repair
expenses resulting from neglect or
inadequate maintenance. It may
also help to maintain the value of
the vehicle if it is sold. ...