Cleaning Procedure
Clean the crankshaft balancer in solvent that is compatiblewith the rubber-(1).
Warning:Refer toSafety Glasses Warning.
Dry the crankshaft balancer with compressed air.Inspection ProcedureInspect the crankshaft balancer for the following:Worn or damaged hub-to-crankshaftsurface-(1)Worn, grooved or damaged hub sealsurface-(2)
A crankshaft balancer hub seal surface with excessivescoring, grooves, rust or other damage must be replaced.
Worn, chunking or deteriorated rubber between the hub andpulley-(3)Damaged drive belt ribs-(4)Damaged webs-(5)Repair or replace the crankshaft balancer asnecessary.Low and Reverse and 1-2-3-4 Clutch Housing Cleaning and Inspection Automatic Transmission Unit Automatic Clutches
Low and Reverse and 1-2-3-4 Clutch Housing Cleaning and InspectionCalloutComponent NameCaution:After cleaning the transmission components, allow to air dry.Do not use cloth or paper towels in order to dry any transmissioncomponents. Lint from the towels can cause componentfailure.Caution:Do not reus ...