Caution:Use the Evaporative Emission (EVAP) System Tester (EEST) GE41413-A in order to provide a clean, dry, low pressure nitrogen gassource. Do not substitute any other pressurized source, gas orotherwise. Damage may result to the EVAP system, test equipment orcause a safety risk.
Fastener Caution
DangerBalance Shaft Installation Engine Block Cylinder Block Balance Shaft
Note:This procedure is not used in Europe.Special Tools EN-43650 Balance Shaft Bushing Remover/InstallerFor equivalent regional tools, refer toSpecial Tools.Install the balance shaft bushing using the EN-43650 installer-(1).Seat the balance shaft bushing into the bore using the EN-43650 installer-(1 ...