Some external leaks are caused by case porosity innon-pressurized areas.
Thoroughly clean the area to be repaired with a cleaningsolvent. Air dry the area.Warning:Epoxy adhesive may cause skin irritations and eye damage.Read and follow all information on the container label as providedby the manufacturer.
Using instructions from the manufacturer, mix a sufficientamount of an epoxy to make the repair.Apply the epoxy. A clean, dry soldering acid brush can beused to clean the area and also to apply the epoxy cement. Makecertain that the area to be repaired is fully covered.Allow the epoxy cement to cure for three hours beforeassembling the components.Repeat the fluid leak diagnosis procedures.
Shift Solenoid Valve State and Gear Ratio Automatic Transmission Unit Transmission Shift Solenoids
Manual Shift Detent Lever with Shaft Position Switch Assembly Replacement Automatic Transmission UnitHood Primary and Secondary Latch Replacement (Terrain) Panels
Hood Primary and Secondary Latch ReplacementCalloutComponent Name1Hood Primary and Secondary Latch Bolt (Qty:-2)Caution:Refer toFastener Caution.ProcedureMark location of hood latch to avoid the need to realign after installation.Insert long-handled trim tool into latch opening under plastic panel t ...