1 | A/Trans Case Cover Assembly Bolt-M6-x-30-(Qty:-10) |
2 | A/Trans Case Cover Assembly Caution:Use care when pulling the input speed sensor wire harnessthrough the case to avoid damaging the harness. |
3 | A/Trans Case Cover Gasket Note:The gasket is not reusable. |
4 | Input Shaft Thrust Bearing Assembly Note:The bearing may be stuck to the case cover. |
5 | 3–5 Rev/4–5–6 Clutch Housing Assembly |
Ignition Coil Replacement - Bank 2 Engine Control
Removal ProcedureRemove the intake manifold cover. Refer toIntake Manifold Cover Replacement.Disconnect the engine wiring harness electrical connector(s) (5) from the ignitioncoil(s) (4).Remove the ignition coil bolt(s).Remove the ignition coil(s).Installation ProcedureInstall the ignition coil(s).C ...