The brake pressure sensor does not require calibration often.Calibration of the brake pressure sensor might be required aftercertain service procedures are performed. Some of these proceduresare as follows:
Electronic brake control module (EBCM) replacementBrake pressure modulator valve assembly replacementThe Brake Pressure Sensor Calibration procedure can becompleted with a scan tool using the following steps:
Apply the parking brake, or set the transmission in the Pposition.Release the brake pedal.Install the scan tool to the data link connector.Ignition ON, engine OFFSelect Brake Pressure Sensor Calibration in the EBCMConfiguration/Reset Functions list.Follow the scan tool directions to complete the calibrationprocedure.Clear any DTCs that may be set.Outside Rearview Mirror Remote Control Switch Replacement Rearview
Outside Rearview Mirror Remote Control Switch ReplacementCalloutComponent NamePreliminary ProcedureRemove the front side door accessory switch mount plate.Refer toFront Side Door Accessory Switch Mount Plate Replacement.1Outside Remote Control Rearview Mirror Switch AssemblyProcedureDisconnect the e ...