Warning:When performing service on or near the SIR components or theSIR wiring, the SIR system must be disabled. Refer to SIR Disablingand Enabling . Failure to observe the correct procedure could causedeployment of the SIR components, personal injury, or unnecessarySIR system repairs. Warning:Do not strike or jolt the inflatable restraint side impactsensor (SIS). Before applying power to the SIS make sure that it issecurely fastened. Failure to observe the correct installationprocedures could cause SIR deployment, personal injury, orunnecessary SIR system repairs. Preliminary ProceduresDisable the supplemental inflatable restraint (SIR) system.Refer toSIR Disabling and Enabling.Remove the front side door trim panel. Refer toFront Side Door Trim Panel Replacement. | |
1 | Inflatable Restraint Side Impact Sensor Assembly Caution:Refer toFastener Caution. ProcedureLoosen the fastener and slide the sensor out of the keyholeslot.The bolt is integral to the sensor assembly, DO NOT removeseparately.Tip:The sensor is located on the inside of the front door innerpanel. Tighten7.5-Y(66-lb-in) |
Folded-Over Wire Repair
Special Tools EL-38125-10 Splice Sleeve Crimping ToolFor equivalent regional tools, refer toSpecial Tools.The GM global wire repair strategy uses connector assemblies (pigtails) and terminatedleads to repair wiring harnesses.To reduce and manage GM Service Parts proliferation, the service pigtails a ...