Special Tools DT-46620Seal Installer For equivalent regional tools, refer toSpecial Tools. | |
1 | 3–5 Reverse and 4–5–6 ClutchFluid Seals-(Qty:-3) ProcedurePlace DT-46620-3 which is part ofDT-46620seal installerover the case hub and adjust it so that only the bottomseal ring is exposed.Place a NEW fluid seal ring ontoDT-46620-3 which is part ofDT-46620seal installer.Use DT-46620-2 which is part ofDT-46620seal installerto push the fluid seal ring down overDT-46620-3 which is part ofDT-46620seal installerinto the hub ring groove.Repeat the above steps to install all 3-sealrings, adjusting DT-46620-3 which is part ofDT-46620seal installerto the appropriate ring groove. |
2 | Small Chamfer Up Caution:Do not force the seal installer down over the seals as thiswill roll and damage the seals. The large chamfer is designed tofit over the over stretched seal. Use a hand to help shrink theseal if the seal installer is difficult to install over the sealrings. Procedure Install DT-46620-1 which is part ofDT-46620seal installerwith the large chamfer end down over the fluid seal ringsand leave DT-46620-1 which is part ofDT-46620seal installeron the seals for at least 60 seconds. |
3 | Large Chamfer Up ProcedureInstall DT-46620-1 which is part ofDT-46620seal installerwith the small chamfer end facing down for at least 60seconds. This will properly size the bottom seal ring.Leaving DT-46620-1 which is part ofDT-46620seal installeron the fluid seal rings for an extended period of timecould cause a fluid leak on the initial clutch piston circuit untilthe seal rings warm up and expand to the proper dimension. |
Front View Camera Module Programming and Setup
Note:DO NOT program a control module unless directed to by a service procedure or a servicebulletin. If the control module is not properly configured with the correct calibrationsoftware, the control module will not control all of the vehicle features properly.Ensure the programming tool is equipped ...