The mechanical components of the 6T40/45/50 are as follows:
A torque converter with an electronically controlled capacity clutch-(ECCC)Gear-type fluid pump assembly1–2–3–4 and low and reverse clutch housing assembly4–5–6 and 3–5 reverse clutch housing assembly2–6 clutch assemblyLow and reverse clutch (one way clutch) assemblyControl valve body assemblyDrive sprocket, driven sprocket and link assemblyFront differential carrier assemblyInput Carrier AssemblyReaction Carrier AssemblyOutput Carrier AssemblyThe electrical components of the 6T40/45/50 are as follows:
Output speed sensor assemblyInput speed sensor assemblyManual shift shaft with internal mode switchControl solenoid valve assembly, which contains the following components:Transmission control module-(TCM)5 variable bleed line pressure control-(PC) solenoidsTransmission fluid pressure-(TFP) switch assemblyTorque converter clutch-(TCC) pressure control solenoidshift solenoidTransmission fluid temperature sensorFor more information, refer toElectronic Component Description.
Transmission General Description Automatic Transmission Unit
Transmission Component and System Description Automatic Transmission UnitCrankshaft Balancer Installation Engine Block Cylinder Block Crankshaft
Special ToolsEN 41998-B Crankshaft Balancer InstallerEN 45059 Angle MeterEN 46106 Engine Flywheel Holding ToolFor equivalent regional tools, refer toSpecial Tools.The EN 46106 toolmust be installed onto the flywheel.Use the EN 41998-B installer, nut, bearing and washer to install the crankshaft bala ...