Caution:Use the correct fastener in the correct location. Replacementfasteners must be the correct part number for that application. Donot use paints, lubricants, or corrosion inhibitors on fasteners,or fastener joint surfaces, unless specified. These coatings affectfastener torque and joint clamping force and may damage thefastener. Use the correct tightening sequence and specificationswhen installing fasteners in order to avoid damage to parts andsystems. When using fasteners that are threaded directly intoplastic, use extreme care not to strip the mating plastic part(s).Use hand tools only, and do not use any kind of impact or powertools. Fastener should be hand tightened, fully seated, and notstripped.
Pipe Wrench Positioning Caution
Clean, Dry, Low Pressure Gas Source CautionCrankshaft Balancer Removal Engine Block Cylinder Block Crankshaft
Special ToolsEN 43653Flywheel Holding ToolFor equivalent regional tools, refer toSpecial Tools/_iv,:InstallEN 43653holding tool-(1) in the starter assembly location, engagingthe flywheel, in order to prevent crankshaft rotation.Remove the balancer retaining bolt-(1) and washer.Discard the bolt.Remov ...