Chevrolet Equinox Service Manual: Diagnostic Repair Verification
Note:After a repair has been made, some DTCs require the ignition to be turned OFF thenback ON before the scan tool function will clear the DTC.
Ignition OFF.Install any components or connectors that have been removed or replaced during diagnosis.Perform any adjustment, programming or setup procedures that are required when a componentor module is removed or replaced.Ignition ON.Clear the DTCs.Turn the ignition OFF for 60 seconds.If the repair was related to a DTC, duplicate the Conditions for Running the DTC anduse the Freeze Frame/Failure Records, if applicable, in order to verify the DTC doesnot set. If the DTC sets or another DTC is present, refer to theDiagnostic Trouble Code (DTC) List - Vehicleand perform the appropriate diagnostic procedure.Or
If the repair was symptom related, duplicate the conditions under which the customerconcern occurred to verify the repair. If the customer concern reoccurs or anothersymptom is present, return toSymptoms - Vehicleand perform the appropriate symptom diagnostic.
Exterior Care
LocksLocks are lubricated at the factory. Use a de-icing agent only when absolutely necessary,and have the locks greased after using. SeeRecommended Fluids and Lubricants.Washing the VehicleTo preserv ...
Front View Camera Module Programming and Setup
Note:DO NOT program a control module unless directed to by a service procedure or a servicebulletin. If the control module is not properly configured with the correct calibrationsoftware, the control ...
Other materials:
Starter Replacement (LEA) Starting System Starter
Removal ProcedureDisconnect the negative battery cable. Refer toBattery Negative Cable Disconnection and Connection.Remove the power vacuum brake booster pump. Refer toPower Brake Booster Pump ReplacementRaise and support the vehicle. Refer toLifting and Jacking the Vehicle.Disconnect the engine har ...
