Chevrolet Equinox manuals

Chevrolet Equinox Owners Manual: Programming the Universal Remote System

For questions or help programming the Universal Remote system, call 1-800-355-3515 or see www.homelink.com.

Programming involves time-sensitive actions, and may time out causing the procedure to be repeated.

To program up to three devices:

  1.  Hold the end of the hand-held transmitter about 3 to 8 cm (1 to 3 in) away from the Universal Remote system buttons with the indicator light in view. The hand-held transmitter was supplied by the manufacturer of the garage door opener receiver.
  2.  At the same time, press and hold both the hand-held transmitter button and one of the three Universal Remote system buttons to be used to operate the garage door. Do not release either button until the indicator light changes from a slow to a rapid flash. Then release both buttons.

    Some garage door openers may require substitution of Step 2 with the procedure under "Radio Signals for Canada and Some Gate Operators" later in this section.

  3.  Press and hold the newly programmed Universal Remote system button for five seconds while watching the indicator light and garage door activation.

Learn or Smart Button
Learn or Smart Button

  1. After completing Steps 1-3, locate the Learn or Smart button inside the garage on the garage door opener receiver.

    The name and color of the button may vary by manufacturer.

  2.  Press and release the Learn or Smart button. Step 6 must be completed within 30 seconds of pressing this button.
  3.  Inside the vehicle, press and hold the newly programmed Universal Remote system button for two seconds and then release it. If the garage door does not move or the lamp on the garage door opener receiver does not flash, press and hold the same button a second time for two seconds, then release it.

    Again, if the door does not move or the garage door lamp does not flash, press and hold the same button a third time for two seconds, then release it.

The Universal Remote system should now activate the garage door.

Repeat the process for programming the two remaining buttons.

Universal Remote System Programming
If equipped, these buttons are in the overhead console. This system can replace up to three remote control transmitters used to activate devices such as garage door openers, security system ...

Radio Signals for Canada and Some Gate Operators
For questions or programming help call 1-800-355-3515 or see www.homelink.com. Canadian radio-frequency laws and some U.S. gate operators require transmitter signals to time out or quit after ...

Other materials:

Reading Lamps
There are reading lamps on the overhead console and over the rear passenger doors. These lamps come on when any door is opened. Front Reading Lamps The front reading lamps are in the overhead console. Press the lamp lenses to turn the front reading lamps on or off. Rear Reading La ...

© 2017-2024 Copyright www.cequinox.com