Chevrolet Equinox Owners Manual: EPB Release
To release the EPB:
- Turn the ignition on, or to ACC/ ACCESSORY.
- Apply and hold the brake pedal.
- Press the EPB switch momentarily.
The EPB is released when the
or PARK light is off.
If the 
light is on, release the
EPB
by pressing and holding the EPB
switch. Continue to hold the switch
until the
or PARK light is off.
If either light stays on after release is attempted, see your dealer.
| Caution
Driving with the parking brake on
can overheat the brake system
and cause premature wear or
damage to brake system parts. Make sure that the parking brake is fully released and the brake warning light is off before driving. |
Automatic EPB Release
Avoid rapid acceleration when the EPB is applied, to preserve parking brake lining life.
The EPB will automatically release when the engine is running, the transmission is placed into gear, and an attempt is made to drive away by pressing the accelerator pedal.
If parking on a hill, or if the vehicle is pulling a trailer, see Driving Characteristics and Towing Tips.
EPB Apply
To apply the EPB:
Be sure the vehicle is at a
complete stop.
Pull the switch momentarily.
Theor PARK light will flash and
then stay on once the EPB is fully
applied. If theor ...
Brake Assist
The Brake Assist feature is
designed to assist the driver in
stopping or decreasing vehicle
speed in emergency driving
conditions. This feature uses the
stability system hydraulic brake
control ...
Other materials:
Camshaft Replacement - Right Side Valvetrain Camshaft
Removal ProcedureRemove the camshaft position actuators. Refer toCamshaft Position Actuator Replacement - Bank 1.Observe the markings on the bearing caps-(1). Each bearing cap is marked in orderto identify its location. The markings have the following meanings:The raised feature must always be orien ...
